fbpx

Mojave MA-300

Our take on a '67, with switchable cardioid, omni, and bidirectional polar patterns.

The MA-300 is a multi-pattern large diaphragm, vacuum tube condenser microphone. Based upon the widely accepted MA-200 designed by David Royer, the MA-300 adds a continuously variable pickup pattern selector, 15dB pad, and a switchable bass roll-off. The MA-300 gives warm, full-bodied reproductions of vocals and instruments, with none of the shrillness and high-frequency distortion artifacts that are often encountered with modern condenser microphones.

Utilizing hand-selected, dual-diaphragm 3-micron capsules, high-quality custom-wound audio transformers, and military-grade JAN 5840 vacuum tubes, the MA-300 performs at a level reminiscent of some of the best-loved classic condenser microphones. The MA-300 power supply can be set for 115V and 230V, 50 or 60 Hz, through an internal switch (100V is also available). Each MA-300 microphone, power supply, and cable set is burned in for 24 hours, carefully tested and evaluated, then packaged in its protective case-within-a-case.orem

MA-300 Features

K67 Style Capsule

Gold-sputtered capsule based on German U67 and U87 style microphones.

Multi-Pattern

Switch between omni, cardioid, and figure-of-eight pattern.

Vacuum Tube

Warm, full bodied, with smooth top end.

  • Remotely controlled, continuously variable polar pattern selector
  • Switchable 15dB pad
  • Switchable Bass Roll-off
  • Hand-selected 3-micron double diaphragm capsule
  • Custom Mojave transformer
  • Military grade JAN 5840 vacuum tube
  • Internal switchable power supply voltage
  • Ultra clean signal path

DAVID ROYER EXPLAINS THE MA-300

Technical Information

Specifications

  • TRANSDUCER TYPE: Externally polarized, pressure gradient capacitor – double diaphragm.
  • DIAPHRAGM: 1-inch diameter, gold sputtered
  • DIAPHRAGM THICKNESS : 3-microns
  • POLAR RESPONSE: Continuously variable from omnidirectional to figure-eight.
  • FREQUENCY RESPONSE: 20 Hz to 20 KHZ, +/-3 dB at “flat” setting of bass cut switch. Bass cut switch provides 6 dB per octave attenuation below 100 Hertz in “cut” setting
  • SENSITIVITY: -37dB re 1V/pa
  • MAXIMUM SPL: 120 dB with pad off, 135 dB with pad on.
  • DISTORTION:< 1% @ 117 dB SPL , < 3% @ 125 dB SPL with pad off, < 1% @ 132 dB SPL, < 3% @ 140 dB SPL with pad on
  • SELF NOISE: 14db nominal, not to exceed 16db (A Weighted)
  • PAD: 15 dB
  • BASS CUT: 6 dB per octave below 100 hertz.
  • DIMENSIONS AND WEIGHT:
    Carrying case with microphone, power supply, shock mount
    and cables: 13 lbs.
    Microphone: 7 5/8″ X 2″, 1 lb.

Polar Pattern + Frequency Response